Thingiverse
Component Tray for Pick and Place
by trevorbattle
13
Downloads
7
Likes
0
Makes
This is a basic 6 x 3 component tray for Pick and Place machines. I use it to load components that do not come on tape or for small runs that make it not worth building up a reel.
The depressions are on 20mm centers, but most machines are aligned optically so you can likely scale it in X or Y to anything and still use it.
The Z height of the tray inside should be scaled to roughly match the height of the PCB on your work surface.
The flanges are for mounting with magnets, see image and
The depressions are on 20mm centers, but most machines are aligned optically so you can likely scale it in X or Y to anything and still use it.
The Z height of the tray inside should be scaled to roughly match the height of the PCB on your work surface.
The flanges are for mounting with magnets, see image and
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in