XT90 Antispark Loopkey Holder

I was tired of struggling to unplug my XT90 antispark loopkey and decided to design one which allowed me to grip it easily.

Solderup the XT90 as thinly as possible as per the photograph. Here I soldered using a 12AWG wire (without silicone).

Print the holder parts, shove the XT90 in as far as it goes, it should be almost flush. Check to see that the lid will close properly, if not either melt the lid slightly or adjust the loopkey wire.

An M3x20 screw prevents the XT90 from sliding back