Thingiverse
Filament Sharpener
by angry_monk
8
Downloads
6
Likes
0
Makes
***STL part file units are in inches!!***
These are two slight mods to idig3d's filament sharpener. I printed their design and it worked 'ok' but I couldn't get a good tip on my filament. I realized this was due to the blade being too close to the filament which is probably just a result of print tolerances.
I tweaked the file so that the hole for the filament was more to-size (will probably require drilling out after print) and so that it was moved away from the blade so it was better ab
These are two slight mods to idig3d's filament sharpener. I printed their design and it worked 'ok' but I couldn't get a good tip on my filament. I realized this was due to the blade being too close to the filament which is probably just a result of print tolerances.
I tweaked the file so that the hole for the filament was more to-size (will probably require drilling out after print) and so that it was moved away from the blade so it was better ab
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in