Thingiverse
Case Stand for Raspberry Pi + 7" LCD
by sgpdude
55
Downloads
40
Likes
0
Makes
Wanted a sturdy stand for this case that I liked: https://www.thingiverse.com/thing:1164446
The left and right pieces are mirrored copies of each other and connect to the LCD screen through the two case parts using M3x10 screws. I also added holes in the base (in a 30mm by 140mm pattern) for mounting if desired.
The stands tilt the display at a 60 degree angle and take less than an hour and half (at the settings I used) to print each.
There isn't much clearance for the micro USB power c
The left and right pieces are mirrored copies of each other and connect to the LCD screen through the two case parts using M3x10 screws. I also added holes in the base (in a 30mm by 140mm pattern) for mounting if desired.
The stands tilt the display at a 60 degree angle and take less than an hour and half (at the settings I used) to print each.
There isn't much clearance for the micro USB power c
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in