Thingiverse
Lockable Wine Bottle Glass Holder 2
by OldGaf
32
Downloads
20
Likes
1
Makes
My second one of these and is a bit more refined.
The "locks" are VERY tight but they will go in without breaking (good luck getting them out again!). If you find them too hard you can always sand down the bottom locking ring a bit or try printing @ 1% or so smaller. Once they snap in they turn very freely.
I printed one in CCTREE "Marble" and gave it a light sanding to hide the layers. It turned out very nice and smooth.
My first one is here:
Say thanks by giving OldGaf a tip a
The "locks" are VERY tight but they will go in without breaking (good luck getting them out again!). If you find them too hard you can always sand down the bottom locking ring a bit or try printing @ 1% or so smaller. Once they snap in they turn very freely.
I printed one in CCTREE "Marble" and gave it a light sanding to hide the layers. It turned out very nice and smooth.
My first one is here:
Say thanks by giving OldGaf a tip a
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in