Thingiverse
Simple Robo R2 E3D Adapter
4
Downloads
6
Likes
0
Makes
This is a simple fix to allow an E3D V6 to fit in a Robo R2 3d printer.
Requirements are only M3 screws that are 6mm longer than the original ones. This part goes between the stock fan shroud and the carriage.
INSTALLATION:
1) Remove fan shroud (two long screws on the bottom of the fan shroud)
2) Find M3 screws at least 6mm longer than the original ones.
3) Replace the shorter screws with the longer ones and put the printed part between the fan shroud and the carriage.
*** Make
Requirements are only M3 screws that are 6mm longer than the original ones. This part goes between the stock fan shroud and the carriage.
INSTALLATION:
1) Remove fan shroud (two long screws on the bottom of the fan shroud)
2) Find M3 screws at least 6mm longer than the original ones.
3) Replace the shorter screws with the longer ones and put the printed part between the fan shroud and the carriage.
*** Make
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in