Thingiverse
Remix of Ender 3 Octoprint Set Up with Power and Light Remote Control
by ctyke
9
Downloads
8
Likes
0
Makes
Remix of https://www.thingiverse.com/thing:3063845
I changed the base to use 2 of the higher voltage relays recommended in original:
https://www.aliexpress.com/item/30A-5V-1-Channel-Relay-Module-Board-With-Optocoupler-H-L-Level-Triger/32814917488.html?
You only need two, one for power and one for 24V LED Lights. The original design had a relay for both power and ground. I just covered the 5 volt pin on the USB cable from RPI to board so it doesn't draw power from the PI.
See the origi
I changed the base to use 2 of the higher voltage relays recommended in original:
https://www.aliexpress.com/item/30A-5V-1-Channel-Relay-Module-Board-With-Optocoupler-H-L-Level-Triger/32814917488.html?
You only need two, one for power and one for 24V LED Lights. The original design had a relay for both power and ground. I just covered the 5 volt pin on the USB cable from RPI to board so it doesn't draw power from the PI.
See the origi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in