Thingiverse
BLV mgn Cube - X Carriage Hexagon frontplate + locker
by Heliart
40
Downloads
29
Likes
0
Makes
UPDATE 2019/08/10:
I designed an additional locker to hold the BLTouch sensor. With this locker it is not possible to use the shield (cover) any longer.
_________________________________________________
UPDATE 2019/08/09:
I corrected the vertical position of the mounting holes for the belts. Now it's a bit better than before. Before the holes were round about 5 mm too low. This generated a pitching moment to the ball bearings.
Additionally I added the missing lower mounting holes.
----
I designed an additional locker to hold the BLTouch sensor. With this locker it is not possible to use the shield (cover) any longer.
_________________________________________________
UPDATE 2019/08/09:
I corrected the vertical position of the mounting holes for the belts. Now it's a bit better than before. Before the holes were round about 5 mm too low. This generated a pitching moment to the ball bearings.
Additionally I added the missing lower mounting holes.
----
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in