Thingiverse
Ender 3 Lead Screw Stabilizer with hotend cable hanger
by markj113
156
Downloads
89
Likes
0
Makes
Ender 3 lead screw stablizer.
Mods:
Bolt holes resized to 3mm to match most others on the ender 3. You can then also use the printable T-Nuts here:
https://www.thingiverse.com/thing:3050607
Vertical supports added below bolt holes to enable easier printing especially in ABS where no cooling fans are used.
Hot end cable hanger added.
Mods:
Bolt holes resized to 3mm to match most others on the ender 3. You can then also use the printable T-Nuts here:
https://www.thingiverse.com/thing:3050607
Vertical supports added below bolt holes to enable easier printing especially in ABS where no cooling fans are used.
Hot end cable hanger added.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in