Thingiverse
Shendrones Nutmeg 460mah Battery Protection/Stand for RotorX Battery
by Clintnation
14
Downloads
14
Likes
0
Makes
Made this battery protection for my Shendrones Nutmeg so it would sit flat, and protect the Lipo. https://rotorbuilds.com/build/16692
Printed with NinjaFlex or TPU, I chose glow in the dark filament, just cuz why not...?
There are very thin tabs, and a channel to slide your velcro strap under, just to keep the pad attached to Nutmeg. You can just slide packs in and out.
I printed this with the battery facing side against the print bed, with sparse supports (~20%). And 30-40% infill, 2-
Printed with NinjaFlex or TPU, I chose glow in the dark filament, just cuz why not...?
There are very thin tabs, and a channel to slide your velcro strap under, just to keep the pad attached to Nutmeg. You can just slide packs in and out.
I printed this with the battery facing side against the print bed, with sparse supports (~20%). And 30-40% infill, 2-
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in