Thingiverse
Liquid / Grout Mixer 3-1/4"D
by Moshprint
51
Downloads
46
Likes
0
Makes
Needed a grout mixer for a tile job and modeled this up in SW2012 and printed. Designed to pick up from the bottom and push down from the top, so discharge is out the sides.
Print the top and base flat side down and fit together with slots on the hub inter-meshing. I'm not sure if it matters, but I staggered the top blades to the base so they were not in-line with each other. The pictures show a previous revision and the current has a lower profile outer ring and streamlined blades.
The s
Print the top and base flat side down and fit together with slots on the hub inter-meshing. I'm not sure if it matters, but I staggered the top blades to the base so they were not in-line with each other. The pictures show a previous revision and the current has a lower profile outer ring and streamlined blades.
The s
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in