Thingiverse
13mm Elbow Aquarium Spraybar
by usulrasolas
13
Downloads
12
Likes
0
Makes
This is a two part spraybar with a 13mm (~1/4 inch) inner diameter pressure fit connection.
Print as two pieces with circle end to build surface for tip and "spray slots". Can handle quite a large flow amount, tested up to 295 gph (marineland 1200 in powerhead mode) and doesn't cause impeller chatter due to backpressure. Modeled and tested with SIMSCALE.
Please print with food safe material or coat with some sort of aquarium safe coating or epoxy for the safety of your fish!
*Added All In
Print as two pieces with circle end to build surface for tip and "spray slots". Can handle quite a large flow amount, tested up to 295 gph (marineland 1200 in powerhead mode) and doesn't cause impeller chatter due to backpressure. Modeled and tested with SIMSCALE.
Please print with food safe material or coat with some sort of aquarium safe coating or epoxy for the safety of your fish!
*Added All In
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in