Thingiverse
HDD wall mount / bracket / holder (WD)
by Dikovinniy
38
Downloads
24
Likes
1
Makes
Hard drive dimensions:
length - 180
width - 116.7
thickness - 36.8
HDD wall mount:
Wall thickness 4.8 mm (0.4 mm nozzle x 12)
On each side of the holder is made a gap of 0.35 mm.
When modeling, I planned to print the model in a vertical position. Therefore, I did not rounded, but beveled edges under 45%, so that the printer would print them well. The maximum angle of overhanging sides of decorative triangles is 50 degrees. It should be equally well printed from both PLA and ABS plastic. T
length - 180
width - 116.7
thickness - 36.8
HDD wall mount:
Wall thickness 4.8 mm (0.4 mm nozzle x 12)
On each side of the holder is made a gap of 0.35 mm.
When modeling, I planned to print the model in a vertical position. Therefore, I did not rounded, but beveled edges under 45%, so that the printer would print them well. The maximum angle of overhanging sides of decorative triangles is 50 degrees. It should be equally well printed from both PLA and ABS plastic. T
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in