Ender3 Z Axis Support

M4 x 10mm Cap screw x 4, M3 x 10mm Cap screw x 4, M4 T nut x 4.

The screw holes are also slightly tightened to prevent loosening.

Fix the stepper motor first, then attach the T-nut through the M4 screw, set it, and tighten each one.

I don't think I'm worried, but please check if there is some slack.

The resolution is 0.1 mm, but I think it may be coarser.

The support was output with concentric circles set to 10%. There is also a support roof and a support floor.

All sentences u