Thingiverse
Printer Feet - Maker Select V2/Duplicator i3
27
Downloads
7
Likes
1
Makes
UPDATE: A Rev2 Corner Foot has been added. It's been beefed up a little, the side tab has been widened, and side frame rail now rests in the bottom of the tab.
The printer needed some feet.
Just something to get in between the metal frame and the table, quiet it down.
These are they.
My Z-braces (GulfCoast Robotics) leave the front and rear bottom frame edges exposed, so it was a corner wrap for the 4 outer corners and a full wrap for the gantrys.
Doublestick tape and some thin
The printer needed some feet.
Just something to get in between the metal frame and the table, quiet it down.
These are they.
My Z-braces (GulfCoast Robotics) leave the front and rear bottom frame edges exposed, so it was a corner wrap for the 4 outer corners and a full wrap for the gantrys.
Doublestick tape and some thin
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in