Thingiverse
Anet A8 Extruder Fan Simple Hinge (with using heatsink)
by jaehong_park
7
Downloads
1
Likes
0
Makes
Designed to move the extruder fan with a hinge while firmly attaching the heat sink to the extruder.
The inserted state of the filament was confirmed by the center hole of the bundle heat sink.
In my case, the bundle heat sink of Anet A8 is strongly bonded to the extruder, which can cause temperature fluctuations.
//Bolt needed//
Fan fastening / plate head screw M3 x 20: 2EA
Hinges Shaft / Screw M3 x 15: 1EA
+
Heat sink fixing / screw M3 x 25: 2EA
Hinge bracket / screw M4 x 12: 2EA
The inserted state of the filament was confirmed by the center hole of the bundle heat sink.
In my case, the bundle heat sink of Anet A8 is strongly bonded to the extruder, which can cause temperature fluctuations.
//Bolt needed//
Fan fastening / plate head screw M3 x 20: 2EA
Hinges Shaft / Screw M3 x 15: 1EA
+
Heat sink fixing / screw M3 x 25: 2EA
Hinge bracket / screw M4 x 12: 2EA
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in