Thingiverse
S&W 686 match grip
by R3ft
29
Downloads
23
Likes
0
Makes
Match grip for S&W 686, medium hand size. Designed for single action/precision shooting. Right-hander version(left-handers mirror it and understand the following instructions the other way round).
Use M5 screws and washers. Print with supports in two parts, outer side up. For printing the right side, place the grip in your slicer on the left side and use offset -19.8mm; for the left side, offset is -28mm. When printing without raft, I had to use sandpaper to remove the curb above the heat bed,
Use M5 screws and washers. Print with supports in two parts, outer side up. For printing the right side, place the grip in your slicer on the left side and use offset -19.8mm; for the left side, offset is -28mm. When printing without raft, I had to use sandpaper to remove the curb above the heat bed,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in