Thingiverse
34mm Microphone Capsule Mount
door ViewUpHere
41
Downloads
25
Likes
1
Makes
This is a combination saddle and post for mounting a 34mm single or dual-backplate K87-style capsule in a generic Chinese microphone body (BM-700 / BM-800) for side-address use.
The mounting holes should match the holes in any of the BM-700 and BM-800 derivative microphones. The one caveat is that some of these microphones only have two of the four holes tapped in their upper plates. The holes are tapped to take M2.5 screws. This will work with only two screws, but if you decide to fully populate the mounting screws, be aware you may need to purchase a tap and tap handle in order to finish the job.
The mounting holes are designed to take shock isolating grommets used for RC servos. Du-Bro #115 "Natural Rubber Grommets for Small Servos" or equivalent work fine.
The stock screws that come with the donor mic will likely be too short to use with this mount because of the additional thickness of the grommets. I used M2.5x6mm screws with M2.5 washers to mount mine. This is the short
The mounting holes should match the holes in any of the BM-700 and BM-800 derivative microphones. The one caveat is that some of these microphones only have two of the four holes tapped in their upper plates. The holes are tapped to take M2.5 screws. This will work with only two screws, but if you decide to fully populate the mounting screws, be aware you may need to purchase a tap and tap handle in order to finish the job.
The mounting holes are designed to take shock isolating grommets used for RC servos. Du-Bro #115 "Natural Rubber Grommets for Small Servos" or equivalent work fine.
The stock screws that come with the donor mic will likely be too short to use with this mount because of the additional thickness of the grommets. I used M2.5x6mm screws with M2.5 washers to mount mine. This is the short
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
