Thingiverse
MPMD Hot End Silicone Sock Mould
by ksihota
59
Downloads
30
Likes
1
Makes
Notes
31/01/2020
I would strongly recommend the soap/IPA release agent (noted below) and allow extra curing time as the thicker walls may take longer for the silicone to harden up enough for removal. I would suggest allowing 48 hours to be sure.
Note: If you do start taking the mould apart and notice the there are soft parts leave it longer to cure. You can also repair damaged parts by carefully spreading some more silicone over the damaged areas and then allowing it to cure.
27/01/202
31/01/2020
I would strongly recommend the soap/IPA release agent (noted below) and allow extra curing time as the thicker walls may take longer for the silicone to harden up enough for removal. I would suggest allowing 48 hours to be sure.
Note: If you do start taking the mould apart and notice the there are soft parts leave it longer to cure. You can also repair damaged parts by carefully spreading some more silicone over the damaged areas and then allowing it to cure.
27/01/202
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in