Primary Arms ACSS Raptor 1-6 FFP Scope Throw Lever

This is a remix I did of two Scope Throw Levers on Thingiverse. It was designed to fit the Primary Arms ACSS Raptor 1-6 FFP Scope. When printed using ABS, it did not take any scaling for me.

I printed the part at 100% infill, used sandpaper to carefully round all the edges, and then did an acetone vapor bath. The results were awesome!

To install, CAREFULLY spread the lever out just as wide as the narrow part of your scope (forward of the zoom setting ring). ABS won't crack, but don't s