Thingiverse
Gantry Bearing Holders
by weston1968
9
Downloads
10
Likes
0
Makes
Updated August 09, 2020
These replace the gantry bearing holders. I got rid of the springs on the belts and went to open loop belting. This gets rid of artifacts resulting from the springs expanding/contracting during acceleration and deceleration. I put bushings in that hold the 6 mm shaft rigid. The 6 mm shafts can not drift because they are secured. The shafts are secured on only one side so that the shafts can shift slightly as the distance between the 8 mm shafts will have some tole
These replace the gantry bearing holders. I got rid of the springs on the belts and went to open loop belting. This gets rid of artifacts resulting from the springs expanding/contracting during acceleration and deceleration. I put bushings in that hold the 6 mm shaft rigid. The 6 mm shafts can not drift because they are secured. The shafts are secured on only one side so that the shafts can shift slightly as the distance between the 8 mm shafts will have some tole
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in