Thingiverse
Universal Joint Z coupler
308
Downloads
243
Likes
5
Makes
An experiment intended to reduce Z wobble in prusa i2 printers.
The holes are deliberately sized to fit perfectly straight off the bed. The holes in the wings should allow an M3 screw to slide through without much resistance but also without much play, the holes in the centerpiece should be super tight so you can actually cut a thread by driving the M3 screw in.
The motor shaft has a single nut trap for the flat, the threaded rod has 3 nut traps in case some alignment is needed.
8x M3x1
The holes are deliberately sized to fit perfectly straight off the bed. The holes in the wings should allow an M3 screw to slide through without much resistance but also without much play, the holes in the centerpiece should be super tight so you can actually cut a thread by driving the M3 screw in.
The motor shaft has a single nut trap for the flat, the threaded rod has 3 nut traps in case some alignment is needed.
8x M3x1
Sign in to leave a comment
Sign in