Thingiverse
Bullet Feeder Die .223 / 5,56
by Icerise
386
Downloads
138
Likes
0
Makes
Hi Folks,
as i were going to load some .223 i was searching for a bullet feeder die on my Hornady LNL AP, like the 9mm one i remixed this from. Unfortunately i didn't find one. So gotta do it myself and here it is.
Tried with 62gr. FMJ-BT bullets and works like a charm.
You will probably have to sand the parts/holes a bit to get smooth sliding.
1x 4mm ball bearing is needed!
-----------------------
The Catcher is designed to be mounted beneath the spring from an automatic bullet fe
as i were going to load some .223 i was searching for a bullet feeder die on my Hornady LNL AP, like the 9mm one i remixed this from. Unfortunately i didn't find one. So gotta do it myself and here it is.
Tried with 62gr. FMJ-BT bullets and works like a charm.
You will probably have to sand the parts/holes a bit to get smooth sliding.
1x 4mm ball bearing is needed!
-----------------------
The Catcher is designed to be mounted beneath the spring from an automatic bullet fe
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in