Thingiverse
Adjustable BL-Touch sensor mount for Ender 3 and CR10 REMIX to use a 4-40 screw and nut (with STEP file)
18
Downloads
10
Likes
0
Makes
Update 4/25/2019
I recommend using the following remix for the base by eric_csuf, which adds some pockets help the base of the mount sit flush to the hot end carriage that it mounts to. It will require supports to print his version, but they should be minimal, just FYI. It looks like a good improvement, and you can find it at the link below (4-40 nut version):
https://www.thingiverse.com/thing:3586322
You will still need to "wing" here, but please use the remix'ed base.
Updated 3/22/
I recommend using the following remix for the base by eric_csuf, which adds some pockets help the base of the mount sit flush to the hot end carriage that it mounts to. It will require supports to print his version, but they should be minimal, just FYI. It looks like a good improvement, and you can find it at the link below (4-40 nut version):
https://www.thingiverse.com/thing:3586322
You will still need to "wing" here, but please use the remix'ed base.
Updated 3/22/
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in