350mm QUAD

Fun little quad. Uses any motor with a 16mm or 19mm mount. Can use up to a 9in prop. Can fit a Pixhawk or APM or any other flight controller you want. Small ESC's fit in the arms. I used RC Timer 40AMP thin.

I printed at .2mm layer height at 35% infill.

I printed in PLA but can be printed in ABS if you can get it to stick. Main body is pretty big so it tends to warp with ABS.

Standard 3DR GPS fits in top plate cut out.

https://youtu.be/yRjFoWTwuAA

Added a new Top Plate we did last we to accommodate a non-3dr gps and some extra room inside.