Thingiverse
Lightsaber Blade for Adafruit Prop-Maker
by otdiggity
18
Downloads
11
Likes
0
Makes
These blades will fit in the PropMaker lightsaber (1" diameter hole) and include a tunnel that can fit a neopixel strip.
Some build photos: https://imgur.com/a/x6ewXp8
The hole dimensions are 2.75mm x 12.5mm, so make sure your neopixels are smaller than that. I used neopixels that had no weather protection, and were 2.4mm x 10mm. they slide right in and they'll hold themselves up without tape.
PLA wasn't strong enough to hold more than 2 or 3 together, they split if you swing wide. N
Some build photos: https://imgur.com/a/x6ewXp8
The hole dimensions are 2.75mm x 12.5mm, so make sure your neopixels are smaller than that. I used neopixels that had no weather protection, and were 2.4mm x 10mm. they slide right in and they'll hold themselves up without tape.
PLA wasn't strong enough to hold more than 2 or 3 together, they split if you swing wide. N
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in