Thingiverse
Parametric customizer used spool refill filament adapter
by mazhive
13
Downloads
9
Likes
1
Makes
UPDATED !!! 10-04-19 !! openscad file mistake in filament wholes..corrected !
Refill filament used on an old spool.
dont get me wrong the masterspool from Richrap is oke but my problem is it takes ages to print.
This takes about 3 hours to print and 5 minutes assembly and it uses far less plastic.
Use 0.4 layer height if you can and it will print fine and fast.
Please telll me how it worked for you !! As i had no problems with it using it.
requirement:
old spool, drill bit 5mm
Refill filament used on an old spool.
dont get me wrong the masterspool from Richrap is oke but my problem is it takes ages to print.
This takes about 3 hours to print and 5 minutes assembly and it uses far less plastic.
Use 0.4 layer height if you can and it will print fine and fast.
Please telll me how it worked for you !! As i had no problems with it using it.
requirement:
old spool, drill bit 5mm
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in