Para Ordinance P14/Kimber BP10 II/BUL M5 mag extensions +2

Measurements where based off of the Arredondo magazine extension for the P14 that I have for my Kimber BP TEN II. The measurements for the base-plate lip slots may be tight on tolerance, scale up an additional 1% if need be. It's recommended to print with supports, rotate the model 15 degrees towards the backside to prevent supports from appearing inside the extension. 80% -100% infill required. May work with PLA due to the amount of plastic that I could place around the lips.

3/23/19 5:50pm