Thingiverse
R016H / R017H Remote Cover for HITACHI BEAMER
3
Downloads
1
Likes
1
Makes
Reverse engineering this part was done with a socket set and a drill bit set.
(how cool is that B-)
It's almost impossible to measure the curves, but with a little help and hacking the brain of the designer (they like using round numbers). Try saying 3,63mm radius in a meeting...
Boss... ok, so 3 3/4 it is...
Thing isn't tested, but I will try and print it tomorrow, not sure if the hang-over limit can be adjusted in the Cura program, but they don't have "real" slicers where I print.
(how cool is that B-)
It's almost impossible to measure the curves, but with a little help and hacking the brain of the designer (they like using round numbers). Try saying 3,63mm radius in a meeting...
Boss... ok, so 3 3/4 it is...
Thing isn't tested, but I will try and print it tomorrow, not sure if the hang-over limit can be adjusted in the Cura program, but they don't have "real" slicers where I print.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in