Thingiverse
HobbyKing Desert Fox Reinforced Rear Suspension Arm
by Thirtybird
19
Downloads
9
Likes
1
Makes
Reinforced Rear Suspension Arm for the HobbyKing Desert Fox
Based on the original arm, with the following changes
* Inner shaft outside diameter decreased from 9.5mm to 9mm
* Inner shaft "notch" removed
* Outer shaft outside diameter decreased from 9.3mm to 9mm
* inner structures thickened.
* Now can be printed without supports, and the arm prints flat against the bed - no annoying gap as in the original.
I've printed mine in Gizmodorks Nylon with 5 perimeters and 30% infill and
Based on the original arm, with the following changes
* Inner shaft outside diameter decreased from 9.5mm to 9mm
* Inner shaft "notch" removed
* Outer shaft outside diameter decreased from 9.3mm to 9mm
* inner structures thickened.
* Now can be printed without supports, and the arm prints flat against the bed - no annoying gap as in the original.
I've printed mine in Gizmodorks Nylon with 5 perimeters and 30% infill and
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in