Thingiverse
Piper 2 - Gantry Cable Chain
by jalanjarosz
9
Downloads
8
Likes
0
Makes
Wanted a clean way to route the gantry wiring of a Piper 2 printer.
Cable chain is raised to be 5mm above the highest point of the gantry. Both Extruder and Gantry ends allow for bi-directional swinging so routed cables won't get into too tight of an arch when head is at max X/Y position.
Links are designed to be open for easy access to wiring
Clips pop in and keep the wires in place.
My bed size is 300mm x 300mm and I used 38 cable_chain_link parts and 38 cable_chain_clips.
Cable chain is raised to be 5mm above the highest point of the gantry. Both Extruder and Gantry ends allow for bi-directional swinging so routed cables won't get into too tight of an arch when head is at max X/Y position.
Links are designed to be open for easy access to wiring
Clips pop in and keep the wires in place.
My bed size is 300mm x 300mm and I used 38 cable_chain_link parts and 38 cable_chain_clips.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in