Thingiverse
Approximate 53mm Prop Cutter for Shendrones Nutmeg
by kwongkan
9
Downloads
11
Likes
0
Makes
# THIS THING IS NOT TESTED
Dremel prop cutting tool, designed to cater prop/duct proximity requirements for Shendrones Nutmeg quadcopter frame.
No moving parts to virtually eliminate tolerance / backlash issues.
Insert 5mm drill bit or standoff from your frame kit as prop shaft.
Use rightmost hole to cut down your props to a slightly oversized diameter - 53.25mm, where duct opening measured from Nutmeg STL is very close to 2.08"/52.832mm, then progrssively use remaining holes to trim
Dremel prop cutting tool, designed to cater prop/duct proximity requirements for Shendrones Nutmeg quadcopter frame.
No moving parts to virtually eliminate tolerance / backlash issues.
Insert 5mm drill bit or standoff from your frame kit as prop shaft.
Use rightmost hole to cut down your props to a slightly oversized diameter - 53.25mm, where duct opening measured from Nutmeg STL is very close to 2.08"/52.832mm, then progrssively use remaining holes to trim
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in