Angel Tea Light for vase printing

Thje original angel is not suitable for clean vase printing. I was remove internal hole structure (INNER_HOLE). It was done with help of negative object made in Tinkercad. Then exported and splitted in Slic3r.org slicer (FORM), saved as parts and reimported again to make positive and some cleaning due rough float math.

If you want to successfull print it as vase, use Slic3r original, not Prusa clone. You need to use adaptive layers from 0.05 to 0.3mm, width 0.7mm to 1mm, depend on your extrud