Thingiverse
Magnetic Probe Mount Bltouch, Anet A6
by Whalin
7
Downloads
9
Likes
0
Makes
After spending some time with my new “X” carriage I felt the need to make a few improvements. Shocking I know!
Having a few prints break loose from the bed during printing, I was concerned that they could potentially damage (bend) the BLtouch probe tip. To that end I figured a “break-away” probe mount could be neat thing.
I purchased a 10 pack (p/n: DH1H1) of Neodymium magnets from K&J Magnetics. The magnets are .100” Dia. X .100 long and quite strong. (the magnets were cheap - shipping w
Having a few prints break loose from the bed during printing, I was concerned that they could potentially damage (bend) the BLtouch probe tip. To that end I figured a “break-away” probe mount could be neat thing.
I purchased a 10 pack (p/n: DH1H1) of Neodymium magnets from K&J Magnetics. The magnets are .100” Dia. X .100 long and quite strong. (the magnets were cheap - shipping w
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in