Thingiverse
X-UAV Snow Goose - VTOL components
by ZoneFPV
89
Downloads
99
Likes
0
Makes
These parts can be used to adapt an X-UAV Snow Goose into a VTOL aircraft.
In addition to the 3D printed parts, hardware is required including nuts, bolts, screws, washers, a 1000mm x 14mm diameter carbon tube, robot servos for the tilt rotors, etc.
The carbon tube needs to be cut to form the rear motor boom and two forward-facing booms for the front motors. You should decide on the lengths of these tubes based on the size of the propellers in your setup. In the images, 12 inch props are
In addition to the 3D printed parts, hardware is required including nuts, bolts, screws, washers, a 1000mm x 14mm diameter carbon tube, robot servos for the tilt rotors, etc.
The carbon tube needs to be cut to form the rear motor boom and two forward-facing booms for the front motors. You should decide on the lengths of these tubes based on the size of the propellers in your setup. In the images, 12 inch props are
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in