Thingiverse
Faucet seal
by imakershop
0
Downloads
0
Likes
0
Makes
I needed to replace a rubber seal for a Fish cleaning table/sink (https://www.amazon.com/dp/B00GI0RF0Y/ref=cm_sw_em_r_mt_dp_U_bDqQCbNH6EAZZ) i use as my workshop sink and decided to print one out of TPU.
I made 3 versions:
- 0.135 in. thick is what i measured for seal i removed. it mostly worked but still drips a little.
- 0.200 in. which seems to do the job.
- 0.200 in. with a 10% taper - just for fun.
I made 3 versions:
- 0.135 in. thick is what i measured for seal i removed. it mostly worked but still drips a little.
- 0.200 in. which seems to do the job.
- 0.200 in. with a 10% taper - just for fun.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in