Thingiverse
Milk & More Bottle Top (Lid)
by Kruttschnitt
20
Downloads
52
Likes
2
Makes
A basic milk bottle top for milk bottle such as the ones delivered by Milk & More.
I started with a very tight fit which was leak-proof but it's to difficult to get off and hence I relaxed it a bit.
This one will still stop spillage if the bottle falls over but if its upside down/on its side for a while some milk will leak.
As rightfully pointed out by applebomb511: "PLA is food safe but due to the ripples/layers it leaves ALOT of room for bacteria so make sure you clean it GOOD!"
I started with a very tight fit which was leak-proof but it's to difficult to get off and hence I relaxed it a bit.
This one will still stop spillage if the bottle falls over but if its upside down/on its side for a while some milk will leak.
As rightfully pointed out by applebomb511: "PLA is food safe but due to the ripples/layers it leaves ALOT of room for bacteria so make sure you clean it GOOD!"
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in