Large handle for 1/4 push connect ball cock

The little 1/4 push connect valves are a bit hard to turn, here's a laser cut pattern to make a nice sized handle. You might also like the corresponding base part (https://www.thingiverse.com/thing:3531435). Cut from 2.7mm (1/8") ply. Assembly is straightforward - stack all the pieces together, glue in two pieces. The two P pieces go in the middle, the hex nut cut out piece goes on the outside. I used an M3 bolt to hold it together.

One of these is used to turn on the fertigator spray in