Thingiverse
Helmet Stand
by pmorrell
102
Downloads
97
Likes
0
Makes
Created a simple helmet stand within Tinkercad to hold the cosplay helmets I have been making.
Four files are included:
1. Helmet Rod.stl which is the support bridge between the base and the upper contact. Measures 330 mm tall (13 inches) and is .6mm in diameter smaller than the other two files. From which my print provided a tight fit where no adhesives were required. Z axis should be shortened or lengthened depending on your height requirements.
2. Helmet Upper.stl is to be used as the
Four files are included:
1. Helmet Rod.stl which is the support bridge between the base and the upper contact. Measures 330 mm tall (13 inches) and is .6mm in diameter smaller than the other two files. From which my print provided a tight fit where no adhesives were required. Z axis should be shortened or lengthened depending on your height requirements.
2. Helmet Upper.stl is to be used as the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in