Thingiverse
OpenScan Controller Faceplate
by Duggem
29
Downloads
11
Likes
0
Makes
I recently built the OpenScan 3D scanner from https://openscan.eu and https://www.thingiverse.com/thing:3050437
The control panel front looked a little plain so I designed an add-on front for it. Not only does it look better, it labels the buttons, power switch, and output ports. It also increases the size of the buttons for easier navigation in the menus.
Instead of designing in holes for the protruding mounting screws, I drilled out the existing holes and countersunk them. These are c
The control panel front looked a little plain so I designed an add-on front for it. Not only does it look better, it labels the buttons, power switch, and output ports. It also increases the size of the buttons for easier navigation in the menus.
Instead of designing in holes for the protruding mounting screws, I drilled out the existing holes and countersunk them. These are c
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in