Thingiverse
Raspberry Pi 3 and Arducam mount for Ender 3 - No extra hardware needed
by birdmanravo
50
Downloads
40
Likes
1
Makes
This is a Raspberry Pi 3 + Camera mount for the ender 3. I didn't find any that fit my requirements so I made one.
+ Most parts prints with no support, and where it's needed support is minimal.
+ No extra hardware to fit and mount the parts.
+ No extra hardware to mount the RPI. Just slide it into place and go.
+ Designed around the inexpensive Arducam, the pi & camera mount accommodates the short 6" ribbon cable it comes with, eliminating the need to buy a replacement.
+ The camera mount
+ Most parts prints with no support, and where it's needed support is minimal.
+ No extra hardware to fit and mount the parts.
+ No extra hardware to mount the RPI. Just slide it into place and go.
+ Designed around the inexpensive Arducam, the pi & camera mount accommodates the short 6" ribbon cable it comes with, eliminating the need to buy a replacement.
+ The camera mount
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in