Thingiverse
Orca 0.42/43/44 Hall-Effect sensor mount
by Aggresive
9
Downloads
10
Likes
0
Makes
This is a mount for auto bed levelling, using a Hall-Effect sensor.
Use a BZP (not stainless) M3x25mm cap head bolt for the plunger.
Use 4mm neodymium magnets. (buckyball cubes).
MAKE SURE THAT THE PROBE IS EXTENDED BEFORE YOU HOME/LEVEL, AS THERE IS NOTHING TO STOP IT DRIVING THE HOTEND INTO THE BUILD PLATE OTHER THAN THIS. (At least in my setup, if the original z-axis endstop was used, you could wire this in parallel as a backup, possibly.)
The part is best printed in ABS, PLA will wa
Use a BZP (not stainless) M3x25mm cap head bolt for the plunger.
Use 4mm neodymium magnets. (buckyball cubes).
MAKE SURE THAT THE PROBE IS EXTENDED BEFORE YOU HOME/LEVEL, AS THERE IS NOTHING TO STOP IT DRIVING THE HOTEND INTO THE BUILD PLATE OTHER THAN THIS. (At least in my setup, if the original z-axis endstop was used, you could wire this in parallel as a backup, possibly.)
The part is best printed in ABS, PLA will wa
Sign in to leave a comment
Sign in