Thingiverse
Vortex Manipulator
by PiperSA
58
Downloads
47
Likes
0
Makes
I was asked by a friend if I could make a print of a Vortex Manipulator the same as the one Dr Who? and Torchwood have so I found some pitchers and copped them and made this I did about 11 copes improved it with each print
I used PLA and ABS with a 0.25 and a 0.35 Tip with supports the size of it is in the black pitcher as close as I could guess
The 1/4 it is round fins/vent holes is a lot of long holes air will go through they start to print from off the bed it was easier to slice this wa
I used PLA and ABS with a 0.25 and a 0.35 Tip with supports the size of it is in the black pitcher as close as I could guess
The 1/4 it is round fins/vent holes is a lot of long holes air will go through they start to print from off the bed it was easier to slice this wa
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in