Thingiverse
Tablet, Pad Camera Mount Holder V4 Final
by burkenater
1
Downloads
1
Likes
0
Makes
Tablet, Pad Camera Mount Holder,(UPDATED) V3
You will need a 7/16 nut for the mount side and it will need to be glued. Some nuts may be larger than some so you may need to trim the slot just a little.
12mm * 12mm is the width of the nut used give or take based on printer tolerances.
Hey If you like my work and want to support me, please visit my youtube channel youtubebtt.com and subscribe thanks.
https://www.youtube.com/watch?v=68ElwNZgZY0&t=4s
You will need a 7/16 nut for the mount side and it will need to be glued. Some nuts may be larger than some so you may need to trim the slot just a little.
12mm * 12mm is the width of the nut used give or take based on printer tolerances.
Hey If you like my work and want to support me, please visit my youtube channel youtubebtt.com and subscribe thanks.
https://www.youtube.com/watch?v=68ElwNZgZY0&t=4s
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in