Thingiverse
Aomway 5.8 GHz omni antenna protector (The Balloon)
by SkymanOne
3
Downloads
7
Likes
0
Makes
2019-05-11 Added an alternative, smaller, bottom section for the short version of this antenna.
2019-05-10 Updated version, slightly smaller and lighter.
This is my antenna protector for the Aomway omni directional FPV antenna.
It consists of three parts, two bottom parts that goes on each side of the coax and then the top dome that screws on to the bottom parts, after that just put a zip tie at the narrowest part.
I designed it to be smooth without any edges that could snag on branch
2019-05-10 Updated version, slightly smaller and lighter.
This is my antenna protector for the Aomway omni directional FPV antenna.
It consists of three parts, two bottom parts that goes on each side of the coax and then the top dome that screws on to the bottom parts, after that just put a zip tie at the narrowest part.
I designed it to be smooth without any edges that could snag on branch
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in