Easy Adjust Bar Clamp M12 threaded rod

**This is a clamp created with an M12 threaded bar.**

One of the two clamps is quick and easy to adjust, just tilt it slightly and slide it, then it goes back up horizontally and the washer inserted inside hooks onto the threaded bar.

The other clamp is tightened with a handle inside which the M12 joint is housed.

In addition to the 3 pieces to be printed, you need:
- 1 x M12 threaded bar (any length)
- 2 x M12 washers (outer diameter 24 mm)
- 1 x M12 joint (length 30 mm)

One of t