Thingiverse
TronXY X5S & SA bed-support System
by Exerqtor
140
Downloads
93
Likes
0
Makes
14.06.2019: V2.1
Found and corrected some dimentional issues i had overseen on the main part in V2.
09.06.2019: V2
Totally redesigned from the bottom up, This is made for 8mm Drylin bearings so the bearing holes are 15.97mm, this is to pre-tention the bearings so they get tight and eliminate as much play as posible. Borrowed the modular lowering block idea from Spegelius with 5mm and 10mm lowering blocks. The support itself will lower the bed 13mm.
I will leave the old versions up
Found and corrected some dimentional issues i had overseen on the main part in V2.
09.06.2019: V2
Totally redesigned from the bottom up, This is made for 8mm Drylin bearings so the bearing holes are 15.97mm, this is to pre-tention the bearings so they get tight and eliminate as much play as posible. Borrowed the modular lowering block idea from Spegelius with 5mm and 10mm lowering blocks. The support itself will lower the bed 13mm.
I will leave the old versions up
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in