Thingiverse
Anet A8 Electronic Case with cable chain
by deepwell
21
Downloads
11
Likes
0
Makes
The case should be printed with support but only touching build-plate, make sure to have brim setup so that the corners don't get curved.
The case has been designed for Anet A8, SKR board or MKS Gen L (they are the same dimensions) with two mosfets. Also the cable chain upgrade for Prusa extruder has been remixed, to fit the cablechain on the case.
important !
Have the "Print Thin Walls" enabled ! - the support for the door holder holes have a support but will not get printed without this
The case has been designed for Anet A8, SKR board or MKS Gen L (they are the same dimensions) with two mosfets. Also the cable chain upgrade for Prusa extruder has been remixed, to fit the cablechain on the case.
important !
Have the "Print Thin Walls" enabled ! - the support for the door holder holes have a support but will not get printed without this
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in