Atomic Pi Case with Baby Breakout

Case for the Atomic Pi Single Board Computer created in Fusion360

Steps to assemble:

1 - Print "Wall" (top piece) with no supports needed

2 - Print "Bottom" piece with supports (they're only used on the countersunk holes)

3 - Attach the Atomic Pi to the Wall piece with 3mm x 6mm hex cap screws. Be aware of the sunken offset section for where the baby breakout will protrude

4 - Affix the Baby Breakout board to the bottom

5 - Screw the bottom piece with 3mm x 8mm hex cap screws