Petsfang V6 Base for Tevo Nereus

This is a remix of the base and wire strain relief from the "Petsfang for Geeetech A30". It will allow you to install an E3D V6, or clone, on the Tevo Nereus using the Petsfang duct from the "Petsfang for Geeetech A30" project by David Petsel.

Print the base and one of the two strain reliefs (I recommend left) from this post. Print the V6 duct and either the 40mm or 30mm cap from the "Petsfang for Geeetech A30" project. Make sure you don't accidentally print the Volcano duct.

Use M3x12